Still need dry clutch/tranny parts.

**Wed Oct 03, 2012 8:18 pm » Post: #1 » Download Post**

I'm still after the following parts if anyone has them;
28242-KV3-840
28238-KV3-840

Really need them for my bike, may even consider a complete transmission just for these parts.

Thanks
Paul
_________________
More **** two strokes than you can shake a **** stick at.

**Wed Oct 03, 2012 9:00 pm » Post: #2 » Download Post**

I have bearings, as I recall they are the same as the wet clutch ones. Spacer is easy to make. Don't think I have the collar.
_________________
If I have to take the carbs off once more...

**Wed Oct 03, 2012 9:42 pm » Post: #3 » Download Post**

Bearings I can get, guess I could make the spacer but the collar is the one being the nightmare. Going to see about getting one made but that could take some time!
_________________
More **** two strokes than you can shake a **** stick at.

**Mon Oct 15, 2012 3:09 pm » Post: #4 » Download Post**

Well I measured Fontyyy's before sending it back, and engineer friend was happy to make one for me!

All going well until his 3 phase packed up in the workshop. Bum.

Plan B, phone Dan and buy a complete mc18sp motor. Mad way to get parts but hopefully will have the 'new' parts once matey sorts his wiring out and I have some spares for the 'Wet' bike..
_________________
More **** two strokes than you can shake a **** stick at.