...Should a freshly rebuilt engine be?

I'm surprised how much wet oily residue is in the cylinders on my bike.

It's freshly rebuilt with the HRC jet kit in etc. I ran it to set the RC valves the HRC way, probably all of 5 minutes in total - enough to see the needle climb to 70 degrees and the slight water weep out of the head nut.

I didn't rev it past maybe 3k, mostly I kept it around the 2k mark.

Was using 98 octane at 30:1 with castrol A747.

30:1 will be very oily.

Especially at 2~3000rpm. You'll do more bad than good by not revving it.

At 30:1 and 2~3k, I'm surprised it didn't just load up an foul the plugs!
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!