Hi all

I cannot get my powervalve servo (PVS) to work. I've built the bike up from a non runner, so I assume the PVS activates the PV and they complete a cycle when you turn on the key? Mine doesn't. Infact they don't work at all, even when the bikes rev'ed beyond 8000.

Is there a way to test the PVS? Any ideas?

Much appreciated

Dan
daniel.williams@punchtaverns.com

It's all in the 250 Tuning section.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

Thanks Andy, I had read the tuning section on setting the PV and disconnecting the TPS block connector. My problem is that I can't get the powervalve / servo to work at all.

Wanted to know how and what to test.

Cheers

Dan

Hi Dan,

Is the PGM ok?

Assuming the valves are free, try removing the servo from frame then remove the pulley and seperate the top and bottom of the servo, be careful as theres quite a few plastic gears in there.

Eventually the motor and the potentiometer will be revield, a simple test on the motor and the pot can be made.

Burnt out motor, snapped wire faulty pot etc.

Never had chance to give the exhausts a good airing yet then!!

Never did get my bike sorted, sold it now

All the best,

Regard's Phil

Phil

Thanks I'll give that a try. No the exhausts are actually still at the place I mentioned having the dints pulles out - only a 3 months wait so far!

Cheers

Dan