When i have the my mc18 in gear with the clutch in (engine not running) its dragging a lot - ie pushing the bike turns the engine over a bit.

Is the only adjustment the one under the clutch cover? I've wound this full travel both ways and dont seem to get any improvement.

Does this point to worn friction plates?

Is pulling the clutch off an easy job for someone thats never done it before?

is the single ball bearing still in there

What about the adjustment at the clutch lever?
_________________
james
Its not how fast you go...Its how you go fast.
MC21 Rothmans
RS250
RC31
CRF250X
748R
Porsche (many)
http://members.rennlist.com/j911brick/rennlist3_002.htm

Try changing your oil.

Both lever and mounting adjustments just control freeplay, not clutch actuation.

Where's this ball bearing?

I'll give the oil change a shot see if it helps, Thanks for the replies guys

Fill the Dirty Gearbox up with fuel and give it the arsenal clean, found that a Fuel Bath does the World of good for freeing up sticky oily grease.

Worked a wonder for freeing up my gears, meshes and shifter cylinder,


_________________
HRC Is Getting Expensive

Its' like the AIR is crappy at Ground level.