This pump came off a low miles MC28SE which was being turned into a race bike in Japan. Looks in nice clean condition.
One of the brass outlets seems to be at a slight angle, I am not sure if this is intentional or not.
Check to see if it looks the correct assembly for your bike as there are a couple of variants.
Note: you will also need the small flat metal bush which fits on the end of the gear drive in the engine case.
£50 + postage
Last edited by Max on Sat Jul 11, 2020 9:50 am; edited 2 times in total
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum