Front fender install?

**Mon Mar 09, 2020 12:53 pm » Post: #1 » Download Post**

Hello I just recently purchased an NSR250 SE and I am putting new plastics on, as the old ones were pretty ugly. Everything is going smoothly except the front fender. I’m curious what the technique is for installing it as I can’t seem to bend it or find an angle the fender will fit between the forks. Maybe a dumb question but the bike had a non original front fender to start with so I am not sure the technique. Any input would be appreciated

**Mon Mar 09, 2020 2:16 pm » Post: #2 » Download Post**

Hello "Niem9", and welcome to NSR-WORLD.

It's a pain, but you will need to remove the front wheel to fit the fender, or you will risk damaging it.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

**Mon Mar 09, 2020 2:37 pm » Post: #3 » Download Post**

Removing the wheel for a fender, what a pain... but I guess it’s what I’ll have to do. Thanks for the reply!

**Mon Mar 09, 2020 4:30 pm » Post: #4 » Download Post**

Just one of those quirks, I'm afraid. They're pretty good to work on generally though, and a lot simpler than any of their contemporaries.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!