Hi folks,

Wanted to replace the bent clip-on handlebars on my MC28 and wondered if anyone could tell me what the factory stock angle is supposed to be? I have a line on a set of 8 degree slope, but think that may not be enough.

Wonder if anyone can tell me a range that'll clear the bodywork and tank?

Thanks in advance.

RZ Rob
_________________
Keep the Rubber Side Down

I've got to say, I'm really disappointed that nobody's chimed in with at least an opinion on this. I belong to a lot of forums and I find all of them helpful. Are there any better forums for NSR owners? If not, I guess I'll give up on the "community" concept.

RZ Rob

There's the American spirit!

Maybe no-one actually knows?!

Most bikes I've seen run OEM or HRC RS clipons (if they want replaceable bars), which are the same angles.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

Andy wrote:Maybe no-one actually knows?!

Most bikes I've seen run OEM or HRC RS clipons (if they want replaceable bars), which are the same angles.

I guess that's the case. For simplicity sake I guess I'll go with the infinitely-adjustable Woodcraft versions.

Sorry if I seemed feisty. Was having a bad day.

RZ Rob
_________________
Keep the Rubber Side Down