whilst messing around in the garage over the x-mas holiday I found out that the mirrors off a V-twin TZR250 fit my MC16 almost the mounts are the same distance apart but the threaded studs are too short so i can't actually get a nut onto the thread to bolt them up. however at least its a start.
now the choice is to attack the mounting frame with a grinder to reduce its width or lenghten the studs
apparently M&P list some pattern mirrors with the same bolt spacing if any one else is struggling to get a good view of the rear

still need to get the engine going yet

SFSR
_________________
one MC16 almost complete and.....

there are some nsr mirrors on e bay at the mo.
_________________
MC21SP - Roth-tax
CBR400 - track
MC21R - sold
MC21SP - sold

Might I suggest you forget the mirror issue until you've got the motor going?
_________________
MC21SP Plaything
BMW F800GS Bumblebee
Triumph 9551 Daytona Big boys toy
FJ1100 Sporting relic
GTS1000 oddball

Dave Ett wrote:Might I suggest you forget the mirror issue until you've got the motor going?

you certainly can suggest that my excuse was that i was bored and its a bit easier to swap mirrors from bike to bike than to replate barrels and forge pistons in my garage

sfsr
_________________
one MC16 almost complete and.....

Dave Ett wrote:Might I suggest you forget the mirror issue until you've got the motor going?

cheeky sod

it will run........just not at the moment , its time up on paddocks in pride of place in the middle of the HRC chilwell shed will come, as soon as i know that the CBR is running all ok, to cold and to lazy to do it at the min.

_________________
MC21SP - Roth-tax
CBR400 - track
MC21R - sold
MC21SP - sold

how bout that dave a double whammy, even you couldnt have possible hoped for that
_________________
MC21SP - Roth-tax
CBR400 - track
MC21R - sold
MC21SP - sold

"Poke 'em with a stick and run away quick!"
_________________
MC21SP Plaything
BMW F800GS Bumblebee
Triumph 9551 Daytona Big boys toy
FJ1100 Sporting relic
GTS1000 oddball