After looking at the carb tuning section for the hose routing of the PJ solenoids, I think I'm good to go. But... I noticed that I have a hose that is connected to the nipple between/below the two PJ solenoids. Where does the other end of this hose connect to?

Thanks,

Jae

Into a 3 way spliter that runs into the bottom of the airbox and onto the X piece.



Those pics are on a link that is on this hidden page* along with a load of other really useful info.

*it's not really hidden but it was never easy to find, it's nigh on impossible now.
_________________
Please do not PM me technical questions, if you can't find it on the Forum start a thread

fontyyy wrote:
Those pics are on a link that is on this hidden page* along with a load of other really useful info.

*it's not really hidden but it was never easy to find, it's nigh on impossible now.

If you go to the Workshop page...

The first link at the top of the page (highlighted in red!) is "Technical Resources", and the last link at the bottom of the page (also highlighted in red!) is, ooh, "Technical Resources"!!
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

Hunting for one of two needles in a haystack is still hunting for needles in a haystack
_________________
Please do not PM me technical questions, if you can't find it on the Forum start a thread

Thanks guys! I connected the 3-way to the extra hose into the airbox and magically, I've got midrange! Sweet!

I'm about to buy a friend's RZ350 so it should be interesting to see how the NSR differs in top and overall powerband.

Jae