parts layout for the RC Valve servo motor

**Wed Jul 19, 2006 5:46 am » Post: #1 » Download Post**

I'm trying to figure out the cable layout for the RC valves.
I couldn't find the servo motor in the parts manual.
can anyone help out?

**Wed Jul 19, 2006 7:15 pm » Post: #2 » Download Post**

On mine not that I suppose it matters.

The top cables do the bottom cyl, the bottoms do the top.

This bit will matter Wink

The cable at the rear of the servo as you look at it sat on the bike goes to the rear of the cylinder (furthest away from the exhaust pipe)

Hope this helps.
_________________
If you dont like the way that i ride.....Stop trying to keep up!!!!!

**Thu Jul 20, 2006 12:45 am » Post: #3 » Download Post**

I figured it out. it seems someone wired it up wrong. the rc valves were moving in opposite directions. Everything is good now.

**Mon Jan 08, 2007 1:07 am » Post: #4 » Download Post**

Are all models RC cabled up the same way as in Micks earlier posting?