Are there any adapters that mounts where the standard brackets are sitting, but allow you to remove the fairing without tools, by removing f.x. a R-clip ?

F.x. to allow these fairing mounts to be used

http://www.sp125racing.com/RS250%20Bodywork.htm
_________________
Poul
"If Life Gets Boring, Risk It!"
MC21SE, KISS box
MC21SP, HRC box, racing loom

Are you thinking of Dzus D-Ring fasteners?

http://www.sportsbike.com.au/accessories_dzus_fasteners.html
_________________
Jerry Lai
NSR250 [MC21SP]

Not DZUS. If you scroll down on the link to " Fairing Mounts" you see the part that attaches to the fairing, that part goes into a piece of alu pipe that again is attached to a cylindrical stud welded on the frame ( on a racing bike, that is) but as the NSR don't have these studs welded to the frame I want a bracket (with the stud), that bolts to the same place , under the frame, as the standard brackets.
_________________
Poul
"If Life Gets Boring, Risk It!"
MC21SE, KISS box
MC21SP, HRC box, racing loom


Last edited by pbekkerh on Fri Oct 21, 2005 4:35 pm; edited 1 time in total

On this link far down, the Side Stay is also shown

http://www.sp125racing.com/PerformanceChassisPartsRS125March2003.htm
_________________
Poul
"If Life Gets Boring, Risk It!"
MC21SE, KISS box
MC21SP, HRC box, racing loom

It's not hard fitting your own quick release stuff - I've done it to my race fairing. You just have to rivit the back plate to the inner part, and Bob's yer uncle!
_________________
MC21SP Plaything
BMW F800GS Bumblebee
Triumph 9551 Daytona Big boys toy
FJ1100 Sporting relic
GTS1000 oddball