Does anyone have a trick for accessing the float bowl drain screws other than removing the carbs? On my bike there is a bump on the crankcase that blocks access to the screw on the right hand/front cylinder carb. And the frame etc. etc. blocks access to the drain screw on the left carb.

Thanks to all who respond

I've yet to find an easy way. I did consider putting small valves at the end of the hoses then leaving screws open so they would be easy to drain, but then i decided that might not be very safe. So, I take the carbs off. It's a bit easier because I don't have the air box anymore, but I think we all feel your pain.

What model? I don't have any problems with my MC21, but like Eric, no airbox. (Just pod filters.) Just need a long thin driver.

Something like this...



https://kaisertech.co.uk/1-0x5-5mm-200mm-slotted
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

Thanks Eric & Andy. MC18 frame, MC28 engine but carbs are for MC18. I'll look for a screw driver like that, hopefully with a bit of flex in the shaft.