Hi
Just stripped the mc16 down after quite a few years of not much use.
I’m after some carb spares just wondering the best place to get some gaskets.

Thanks.

Allens performance, or try David Silver, if you have the part number its easy to go on Silvers site and see if they have them and how much, good luck.
_________________
Proud Father of , 05 ktm 400exc supermoto 2018 honda crf rx supermoto

Allen’s performance that’s it, that’s where I got some jets years ago, I couldn’t remember the name. I’ll give them a try. Thanks

Argh it’s a Honda spare only £58 for the set!

Right, look up GASKET GURU, his name is Dan, he's in Brackley in Northants, he will fabricate any gasket if you have a pattern, I have had several off him over the last few years no problem, he also sometimes sells on the evil bay, if you have no luck I will try and dig out his phone number.
_________________
Proud Father of , 05 ktm 400exc supermoto 2018 honda crf rx supermoto

There are only two gaskets, Les. On the top cover plates for the needles.

The other "gaskets" are formed rubber seals. Two for the float bowls, and two for the carb bodies.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

Yep, wrong again Andy, i'm gonna have to give this up, i'm afraid the old age is catching me up too quick and fuzzing the memory.
_________________
Proud Father of , 05 ktm 400exc supermoto 2018 honda crf rx supermoto

Thanks les, but it’s the rubber float bowl ones that I need.

There are some aftermarket kits on the dreaded auction site, but I can't comment on their quality. As harsh as it seems price-wise though, I wouldn't use anything but the genuine part(s) for the carbs.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!

That works out half the price, but like you say the quality might be questionable, looks like I’ll be putting them back on and hope they hold for a bit longer!
Thanks