Hi hope someone can help?

I am in the process of putting new Studs into the Crankcase for the Cylinder assemblies.
Are there any recommendations eg:
- do I do them hand tight and then just nip them up like the Cylinder Head Studs;
- or do I loctite them and torque them up (if so any ideas on Torque values?).

Many thanks in anticipation.

Best Regards

Philip

From our Honda authorised English Workshop Manual:


_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!