The rubber mounts which attach the airbox to the carbs have been separated from the air box. I noticed some kinda glue with previously fixed then in place. What should I be using to re glue these things in place.
I’ve a spare MC28 airbox, could I use this instead although I know the two aren’t the same.
I think the boots have gone a little hard as they were really difficult to get off the carbs, not like my MC28. Might have to do a little surfin to see if I can get some elsewhere.
i just had to put some on a 21 and they were as hard as a rock ad were NOT going on so i pulled them out put a pot on the stove boiled water put the boots in and boild they for a few min and not they are as soft as a babys bottom _________________ 94 mc28 SE
Whenever the carbs come off [every other day huh Steve?!! ] I am NEVER sure I have the rubbers seated proper.
I may try the hair dryer on them next time.... _________________
Just gone through the same deal, I first scuffed up the old air box with some fine wet and dry. Then used a two part epoxy glue like areldite, once that went off I went round with a load of silacone. It was messy and no work of art but so far so good, couldnt swear it will last foe ever.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum You cannot attach files in this forum You cannot download files in this forum