NSR250.net Forums Logo: Honda NSR 250 Forums, Classifieds and Service Manual in English. Covering All Honda NSR 250 MC16, MC18, MC21 and MC28 models
NSR250.net Forums

#
 
#
 
Performance Engineering

  • NSR250 Forums Index ‹
  • Members Content
  • Members Garage
  • Subscription
  • Transactions
  • FAQ
  • Search
  • Register
  • Log in

View Single Post


 Topic: Pgm IV info 







Andy
Site Admin
 
    Send private message View user's profile
    Reply with quote

Andy » Thu Dec 25, 2014 6:07 pm

There is no link. It's just not hard to do. All the wiresplice is doing is shorting certain wires to earth/ground. Rather than hard solder them, just route them through a switch (or switches -- I've seen someone use 2 switches before, to handle all the wires, but it's rather messy and cumbersome!).

You can see a wiring diagram in the Members section. You will will have to plan it yourself, or take the bike to an electrician.

As I say though, it's pointless, unless you are prepared to change the entire setup every time you flick the switch and insert a different card. The PGM-IV is not as flexible as it was hyped to be, back in 1994.

My advice is, if you have an HRC card/setup, stick with it! If you need an odometer, fit a small unobtrusive LED one suitable for a mountain bike or something.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.


Check us out on Facebook! Please "like" our page!
Back to top

  • NSR250 Forums Index
  • All times are GMT
Powered by phpBB © 2001, 2005 phpBB Group


Hosted by NSR250dotNET © 2008 NSR250dotNET