The MC16 doesn't have a TPS.

To set the valves, run the motor to between 2000rpm and 3000rpm, and the valves will move to the "Hi" position. Switch the motor off (while in the 2~3000rpm range), and either align the marks by eye, or use dowels to align the holes.

Make sure there is a little slack in the cables, as if they are tight it can burn out the RC Valve servo and/or the RC controller. (At least the MC16 has a separate controller.)

While the cables are loose, check the Valves move freely by hand. If they are tight, this too can burn out the above components. Plenty of threads on here about removal, cleaning, and reassembly of them. Seals and E-clips are universal amongst NSR's, but the MC16 valve flaps themselves differ to the other models significantly.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!