You have to chop the black PGM connector (pic. 1) off the harness and also cut the 2 grey connectors of the HRC box (pic. 4).

"Hard wire" the HRC box into the stock wiring harness by soldering the corresponding coloured wires to eachother. Make sure the joins are good soldered joints. You could use bullet connectors but you want as little resistance as possible, so soldered is better.

The 2 grey connectors in pic. 2 are for the G.P.S.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!