NSR250.net Forums Logo: Honda NSR 250 Forums, Classifieds and Service Manual in English. Covering All Honda NSR 250 MC16, MC18, MC21 and MC28 models
NSR250.net Forums

#
 
#
 
Performance Engineering

  • NSR250 Forums Index ‹
  • Members Content
  • Members Garage
  • Subscription
  • Transactions
  • FAQ
  • Search
  • Register
  • Log in

View Single Post


 Topic: killed again please help! 







Max szeged

 
    Send private message View user's profile MSN Messenger
    Reply with quote

Max szeged » Thu Dec 25, 2008 10:25 pm

Ok here goes. I opened both carburetors up. (Separately as my master said)
Both float heights are 18mm by using a ruler.
Main jets are both 115
Slow jets which are in the wholes are not able to tell. Can’t get them out yet will need to buy a better fit screwdriver.
The left slow jet is damaged inside someone must have tried to take it out but did not use a proper tool.
So here come the questions:
1. Should I change the float height back to 13mm?
2. My plug on the left cylinder always fowl up when I give a little bit of gas at around 6500rpm. Would this be the result of the bad jet? (will post a jet picture soon)
_________________
feel the wind
Back to top

  • NSR250 Forums Index
  • All times are GMT
Powered by phpBB © 2001, 2005 phpBB Group


Hosted by NSR250dotNET © 2008 NSR250dotNET