pbekkerh wrote:
Now you are here Andy; haven't you or one of your advanced tinker friends ever put a mutimeter on the RC valve solenoids while the bike was on the dyno ? Or just running on the floor.

Matt's your man for that really! He has a test rig set up on the bench to measure all things ignition.

As far as I am aware, the RC Valve movement and position is governed by the TPS and RPM on the PGMIII. The feed is only +/-12V, and the position of the valve depends on the pre-set perameters programmed into the PGM. A particular throttle position at a particular RPM will have a corresponding RC Valve open/closed position. The sweep of the servo will be down to the transition between one set of perameters to the next.

I could be making it all up though!
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!


Last edited by Andy on Wed Jul 25, 2007 2:54 am; edited 1 time in total