If I wanted to do that with the stock rearsets, I would hack the pushrod in half, and make a pivot point off the front lower mounting. I reckon that would work OK.

I'll rough up a diagram, as it's easier to illustrate than describe... being as I'm no teacher!!



Does that make sense?

Of course the geometry will need a little bit of fiddling with, but I'm sure you can get the idea. This will allow the actuator arm on the selector shaft to stay roughly in the standard orientation.
_________________
Andy.
NSR-WORLD.COM

Please keep all responses to Forum posts on the Forum so that others may benefit.

Please DO NOT PM me for technical advice. My time is precious, and you will probably receive a faster response on the Forum anyway.

Check us out on Facebook! Please "like" our page!