Thanks Matt. I know what stroking is... Just not sure how to go about it on the NSR. You can also grind the crank pin offset, but that would require a specail bearing, and you would likley need special rods to clear the case. But then you loose your rod ratio and you would likely need to re-port it because of the timing change. I don't think this really solves my problem.
_________________
james
Its not how fast you go...Its how you go fast.
MC21 Rothmans
RS250
RC31
CRF250X
748R
Porsche (many)
http://members.rennlist.com/j911brick/rennlist3_002.htm