NSR250.net Forums Logo: Honda NSR 250 Forums, Classifieds and Service Manual in English. Covering All Honda NSR 250 MC16, MC18, MC21 and MC28 models
NSR250.net Forums

#
 
#
 
Performance Engineering

  • NSR250 Forums Index ‹
  • Members Content
  • Members Garage
  • Subscription
  • Transactions
  • FAQ
  • Search
  • Register
  • Log in

View Single Post


 Topic: Running On One Cylinder 







Dave Ett
Site Moderator
Site Moderator
 
    Send private message View user's profile
    Reply with quote

Dave Ett » Sun Nov 27, 2005 4:48 pm

Low compression can cause all kinds of running problems.

There's no gasket kit for a carb remove / refit, as ther're attatched by rubber boots.

If you haven't had it run right so far, then I'd start by removing and thouroughly cleaning the carbs. If you don't know the condition of them, it's the safest thing to do - blocked jets could sieze the engine.

I know it's a bit of a pain, and swapping electrical parts may be easier, but I think you need to do it anyway.

How much charge is in the battery when the engine isn't running? When you do get it running, and hold it above 2000rpm, how much charge is there?

This will tell us if the charging circuit and battery are ok.
_________________
MC21SP Plaything
BMW F800GS Bumblebee
Triumph 9551 Daytona Big boys toy
FJ1100 Sporting relic
GTS1000 oddball

Back to top

  • NSR250 Forums Index
  • All times are GMT
Powered by phpBB © 2001, 2005 phpBB Group


Hosted by NSR250dotNET © 2008 NSR250dotNET