From what I can tell, these won't do much unless you're going at low speed (down on a knee for some of you) out on an open road and you hit a small patch of gravel, oil, small yet perfectly round sticks or your motor hiccups and the rear wheel kicks out from under you. If you don't hit the ground too hard, you'll slide for a short distance at worst and hopefully these should keep the fairings from touching the ground.




The only two questions I can't figure out is if they make a set of these for the bolt sizes on these bikes and if cutting is required to fit them properly.
_________________
Party hardy all night long till the sun comes up and the cows come home. Yeow!