NSR250.net Forums Logo: Honda NSR 250 Forums, Classifieds and Service Manual in English. Covering All Honda NSR 250 MC16, MC18, MC21 and MC28 models
NSR250.net Forums

#
 
#
 
Performance Engineering

  • NSR250 Forums Index ‹
  • Members Content
  • Members Garage
  • Subscription
  • Transactions
  • FAQ
  • Search
  • Register
  • Log in

View Single Post


 Topic: R2J RC valve set up 







timmyboy757
Supporter - Titanium
Supporter - Titanium
 
    Send private message View user's profile
    Reply with quote

R2J RC valve set up

timmyboy757 » Fri Jan 13, 2017 4:44 pm

Just braved the snow up to the shed to set up my rc valves. As with all nsr jobs I do a 15min job turns into a 2 hour head scratching session Confused . I followed the instructions for rc valve set up but when diconnected the TPS the servo did not cycle to high position as suggested. I pulled the TPS off and checked resistance and was in normal range as per the manual. I had a look around the forum and a post suggested the r2j servo does not rotate when TPS is disconnected? I checked the r2j supplement in the manual and rc valve set up requires engine to be run till servo goes to high then shut down and insert a 3mm screw to stop it turning While cables are adjusted. I haven't run my engine yet so can I just turn servo manually to high then adjust cables? I am running all standard r2j electrics, PGM1, RC controller and sub controller. Thanks
Back to top

  • NSR250 Forums Index
  • All times are GMT
Powered by phpBB © 2001, 2005 phpBB Group


Hosted by NSR250dotNET © 2008 NSR250dotNET